Titanium plate
Titanium alloy has high strength, low density, good mechanical properties, corrosion resistance, high stability and other effects, but the more stable the metal, the more difficult it is to process, so in the production of titanium alloy process is more complex, the cost is higher, so early titanium alloy is mainly used in aircraft engine parts, and rocket, missile flight parts, etc., in addition to the main application areas of titanium alloy is the military, scientific research, making The main application areas of titanium alloys are military and scientific research, making high strength and corrosion resistant parts, but there are very few of them for civilian use. JIANGSU TISCO INDUSTRIAL CO.,LTD is a professional steel production company, which understands the characteristics and production process of various steel products. The following is an introduction to the manufacturing process of titanium plates and the characteristics of titanium plates.
The process of manufacturing titanium plates
Hot forging is a forging process that takes place above the recrystallisation temperature of the metal. Hot rolling is a rolling process that takes place above the recrystallisation temperature. Cold rolling is a rolling process in which the plastic deformation temperature is lower than the recovery temperature. Annealing: A metal heat treatment process in which the metal is slowly heated to a certain temperature, held for a sufficient time, and then cooled at a suitable rate (usually slow, sometimes controlled cooling). Pickling: The immersion of a manufactured part in an aqueous solution of sulphuric acid, etc., to remove thin films such as oxides from the surface of the metal. It is a pre-treatment or intermediate treatment for electroplating, enamelling, rolling and other processes.
Characteristics of titanium plate
1. Titanium seed plate is the surface of the oxide film is equivalent to a good wear-resistant hair separator, the use of titanium seed plate to save the separator, so that the pole plate stripping easy, eliminating the process of pre-treatment of the seed plate, titanium seed plate than copper seed plate to half the light.
2. The service life of a titanium seed plate is more than three times that of a copper plate and can be 10 to 20 years depending on the operating conditions.
3. The crystalline structure of the electrolytic copper produced from titanium seed plates is dense, the surface is flat and smooth and the quality is excellent.
4. No need to apply a separator to the titanium seed plate, thus avoiding contamination of the copper electrolyte.
5. Increased production capacity reduces the production costs of copper electrolyte, resulting in better economic efficiency.
Post time: Nov-28-2022